Leatherman Skeletool Driver Comfort Cover

I recently purchased a Leatherman Skeletool multitool. I absolutely love the tool, but it has one minor problem-- the driver bit (screwdriver) is exposed and digs into my hand when I'm using the pliers.

This is a small slip-on cover to make the tool more ergonomic. It's a quick and easy print that takes ~5 minutes and uses only 262mm of filament.

NOTE: the fit is intentionally very tight. You will need to break the cover in before it moves smoothly. When pulling off the cover, you may need to hold down the bit lock mechanism to keep the bit from popping out.

Recommended Settings

• Walls: 3
• Layer Height: 0.2 mm
• Material: PLA for most uses, PETG/ABS for use in cars/high temperature uses
• Supports: No
• Change Orientation: No