CR-10 Smart PEI Plate Rear Alignment Tabs (Glass to PEI Plate Conversion)

These were made to make it easier to align the PEI build plate on a CR-10 Smart, after converting from the original glass build plate.

You may also need an M3*12 Hex Socket Countersunk Screw, use two of the original washers and use an additional nut to secure the earth wire to the bed. Once done please check that it's earthed with a continuity tester. 

Now to align your plate, butt it up to the rear tabs and align the side of the build plate with the hot plate, keep it pushed towards the rear and lower it down….job done.

If you have found this useful, please like and possibly leave a comment as well as posting your make.