Basic Cell Phone Stand/Holder With Replaceable Color Panels

Goal was a simple stand for my phone that would allow me to have the charging cable plugged in, not use too much filament and give me the ability to customize it in some fairly simple way. The additional panels simply slide in the side to allow for customization in any different color at any time. Could be scaled up to hold a iPad/tablet as it is fairly sturdy (the width of the area that holds the stand is 12.5mm so scale up if needed to accommodate the width of your device). It was printed laying on its side and I did use tree supports only for the area that holds the phone (I placed blockers by the hexagon holes). The version shown is printed with eSun PLA+ gray and orange filament.