Speaker Pivot Mount

Compatibility

This exact mount was made for Samsung SWA 9100S but I think it will fit most of speakers with a screw hook as seen on the picture. If you are not happy with the stock Base, there is a STEP file where you can modify the base and also everything else.

How to print

I recommend to print it at 5 perimeters, a 100% infill and 0.3mm layer height. Use PLA or PET-G. The Base should be printed with the hex hole on top.

Bill of materials

This is all hardware you need for 1 mount:

• M5 nyloc nut - 3 pcs
• M5x16 round head screw - 3 pcs
• M4x10 round head screw - 1 pcs
• 3.5x16 self-tapping countersunk screw - 3pcs (used for mounting to a wall)

Assembly

Prepare:

• Base Pivot
• Speaker mounting plate
• M5n nut 2x
• M5x16r 2x

Insert M5n into the hex holes in Speaker mounting plate. 

If you are having trouble inserting the nuts just use a screw to screw them in.

Screw Speaker mounting plate and Base Pivot together with M5x16r screws.

Tighten it so there is a bit of resistance when rotating the pivot, it will be adjusted correctly later in the assembly

Next screw a M4x10r screw into the Speaker mounting plate. There should be a thread already printed so don't be scared if the screw is hard to screw in. It is partly forming threads into the plastic so it will be a bit harder to screw in.

Now you adjust the M4 screw until it sits perfect in the hook.

Adjust the screw until it holds itself in the hook. It should click into the hook.

When you are satisfied with the M4 screw length, add a bit of superglue on the back of the screw.

Prepare the Base and insert a M5n nut in the Base.

Fasten the Base to a ceiling or bottom of a shelf with 3.5x16 self tapping countersunk screws.

The screws should be flat with the surface of the base otherwise it wont spin.

Screw the Pivot assembly on the base with M5x16r screws and tighten until it spins with a bit of resistance.

Tighten the two side M5 screws until the speaker holds itself in the 90° position.

Now just connect wires into your speaker rotate it in the direction you like and enjoy : )