Everything Presence One - MMWave Stabilisation Sleeve

The MMWave sensor in my Everything Presence One was a little ‘wobbly’.
This is a very simple sleeve that slips over whichever header you are using and removes angular torque from the MMWave pins.

The render shows the part mounted on the side MMWave header - coloured in gold.

Print at 0.12 layer height.

I am the designer of the official EP1 case.
You can check out my range of tablet wall mounts by following this this link.

These are also available to purchase pre-printed.

Web site (UK shipping only): https://the3droom.co.uk

eBay (Global shipping): The 3D Room on eBay