ALU profile angled cable holder

To provide better cable management I needed cable holder that holds cable in 45° angle. This is not doable with zip ties. Designed part requires single bolt + T nut to stay in place. Cable is fixed in proper angle, position and length.

Print instructions

Category: 3D Printer Accessories Summary

To provide better cable management I needed cable holder that holds cable in 45° angle. This is not doable with zip ties. Designed part requires single bolt + T nut to stay in place. Cable is fixed in proper angle, position and length.

Print Settings

Supports: Yes

Notes:

PETG is preferred but you can use any material. PLA could bent a little over time even at low temperatures. Due to its length and small thickness it will be somehow flexible.

Print it on the longer side with a support for the block. To make it easy, use support from build plate only.