Philips Hue 2 gang switch holder

In the pursuit of an intuitive smart home, I found that I needed to mount two Phillips hue smart switches to a wall to control a few smart lights. Instead of using the bulky stock mounts, I designed a part to mount two hue remotes with some colour accents too!

NOTE: Designed to fit the 1st generation dimmer switches 2nd gen ones are in the works!

Instructions

1. Prepare all the parts
   1. 1x base
   2. 2x accent
   3. 4x magnets (15x3mm magnets, what is used in the stock holder)
2. Insert the accent parts into the base. You may need to lightly file the accents, and use a small amount of superglue.
3. Insert the 4 magnets. You can remove these from the stock holders with a little heat from a heat gun and a screwdriver. Press these into the printed part. Superglue may help but also may not be necessary.

Printing instructions