Magnetic Pen Holder

This is a magnetic pen holder that I made to hold a dry erase marker on my fridge. This is inspired by similar ones I saw that had cutouts for magnets. I didn't want cutouts for two reasons:

• More versatile 
  • Works with any size magnets via glue
• Provides some spacing so I can get my finger behind it if I need to move it. 

The back is a little thicker so if you want to print more solid and drill out holes for your magnets it can do that as well. 

Printing Notes:

• PLA+
• Recommended to print with the smaller flat edge on the bed for easy no supports.
  • I printed this with the large flat part down with no supports and it did work. 
    • It did manage just fine but had minor stringing internally for the last bit where the curve meets in the middle.