Adafruit Featherboard Case

This snap fit case was designed for the purpose of an at-home application for use of WLED on an ESP32 development board. The Adafruit ESP32 Featherboard V2 (HUZZAH) was used to design this. One of the openings is used for USB C cable to power the board and the other is to insert any cables running out of the case (i.e. LED strip V+, V- and Data). The development board can be mounted with M2x6mm machine screws.

Overall Dimensions: 60mm x 32mm x 21mm

3D PRINTING SETTINGS

Only tested with PLA:

Extruder Temp: 190C
Bed Temp: 60C
Infill: Any - Walls are close enough together to be rigid with low infill
Adhesion: Skirt - No raft necessary
Supports: None