Skadis Feet

I rent an apartment, so putting mounting holes in the wall for my Ikea Skadis board is less than ideal. These feet help keep the Skadis stable on my work table (with some rubber pads to keep it from sliding around).

Still testing the balance but placing heaver items on the lower half of the board seems to work well.

WHAT YOU NEED

Printing:

I recommend a larger nozzle with more perimeters and minimal infill. My settings were:

• 3 Perimeters, 5% Infill, 0.6mm Nozzle and PETG

Hardware:

I used M5x25 hex bolts (although I think it should work with M5x20) and M5 nuts inserted into a 3D print to increase the contact area and make it easy to hand tighten.

See that model here:

M5 Nut Knob