Balancing Act Eyeglass Holder

Perfectly balanced, almost like it's floating in the air, showing off your glasses, ready to grab your attention at the slightest movement. (If the surface on which the holder is placed moves, the glasses will wobble.)

Printed in PLA with nozzle size 0.4, layer thickness

 0.2, infill 30%. Use support on buildplate (only) for

 the left bar! The other parts need no support.

Width for the temples is 120-144mm. These will almost always fit. 

Assembly is with press fits. If necessary, use pliers to press the left and right bars together.

Since the holder is quite light, place your other hand on both legs of the base and place the glasses. In about an area of 1cm, the placement is stable. It's very easy to place correctly. But.. too far back will tilt the glasses backward and too far forward will tilt them forward. Due to the smoothness of the PLA, the glasses then slip out. Optionally, you can add anti-slip tape, so that the glasses do not easily slip out. I didn't think this was appropriate, it is after all a balancing act.

A kit card has also been added. Make sure you also use the support on buildplate there! You can possibly remove the support before you give it away.

For XL brains, scale the left and right bar in length only (max. +10%). For XS brains, scale both down in length (max. -10%). Do not use the kitcard in both cases. If you don't know or don't mind, use the original files or kitcard.