Neck Shave Guide & Guard

I actually started shaving my own head in November of 2019 and came up with this to trim my neckline. I figure it should be helpful for anyone living alone in self-quarantine.

The peg is a handle. Just place the half-circle over your neck where you want your hairline to start and keep your non-dominant hand on the handle. Then shave your neck below the guard. I find shaving up to the guard (instead of down and away from) gives a more even result.

It's a pretty straightforward print. I like 20% cubic prints for durability and 0.2mm layers.

9-28-2020: Added V2, an easier and faster print

Print Settings

Printer Brand:

Wanhao

Printer:

Wanhao Duplicator i3 V2

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2mm

Infill:

20% cubic

Filament: 3D Solutech PLA Silver

Notes:

Any infill will probably work, but 20% cubic gives some sturdiness.