Monitor stand with Honeycomb pattern and two shelves for storage

This monitor stand requires no screws or glue if your plywood (or other material for the shelves) fits well. Dimensions are 200mm wide x 140mm high x 20mm extrusion depth.

In the slicer, you can customise to your liking, but these were my settings: 

• PLA
• 6 perimeters for strength
• Infill 7% Honeycomb (fill angle 0°)
• 0 layers top and 0 layers bottom (to expose the infill pattern)
• to add with plate adhesion, you may want to add a brim

I found if you play with the infill settings, you can get some other nice patterns out of it.