Prusament Extension Cord/Socket

I don't have any Prusament Spool available, but I'm trying to enter the contest anyway by referring to this link https://cults3d.com/en/3d-model/art/prusament-spool-simplified-3d-model

Re-purpose your empty Prusament Spool by converting them into an extension cord. You can bring them them anywhere and extend any need for electrical appliance that out of reach with one of Prusa's swag.

The assembly should be pretty straightforward, refer to the picture above for which parts goes to which

BOM

• 14x M3 Nuts
• 8x M3 x 10mm Bolts
• 6x M3 x 22mm Bolts (minimum 22mm)
• UK Socket Panel (86 x 86 x 30mm)
• 3 core flexible wires or similar with any desired length.
• Prusament spool

Print instructions

The parts were modeled in such there are minimal support required yet emphasizes rigidity.

• 2x handles
• 2x leg
• 2x spacer ring
• 2x Bushing
• 1x socket adapter or socket adapter long depending on your screw size and socket type
• 1x Winder
• 1x Hub - you may need support for the nut trap inside, but I doubt you'll even need it
• 1x Handle block - To prevent handle from going off on its own