Makebase MKS PI and TS-35 Case

This is a single case for the MKS PI and the TS-35 display running Klipper
from MakerBase. This case combines the MKS PI board and the display into a
single module.

Support material is not required to print the 4 required parts. An infill of
20% is recommended. For the CPUBoardTopPlateVertical, an 25% infill, 6 
bottom layers, 6 top layers and 3 vertical layers are recommended. This part needs to
be sturdy.

You'll need the following hardware to assemble it:

• Four M5 x 10 mm screws
• Two M5 T-nuts
• Two M5 nuts
• Four M3 x 15 mm screws
• Four M2.5 x 10 mm screws
• Optionally a 30 mm x 8 mm fan

Some of the screws can be replaced with some glue or may be substituted. Do
not overtighten the screws.

Make sure that the connector of the screen is on your left when the display is
set at its final position. This will ensure that the content of the display is
upright.

The four printed parts should be assembled in this order:

1) The ScreenBackPlate and the CPUBoardTopPlateVertical must be assembled
first. Put both flat sides against each other. The holes in each of them must
be aligned. Use two M5 x 10 mm screws along with two nuts. The
CPUBoardTopPlateVertical part shall be centered relative to the
ScreenBackPlate.

2) Put the TS-35 screen in the bezel named ScreenBezelNoBrassInserts. Install
the bezel on the ScreenBackPlate. Make sure that the screen connector is above
the slot in the bezel. Pass the end of the flat cable in the slot. I suggest
putting the unused length in the bezel. Handle the flat cable with care. It is
fragile. Use four M3 x 15 mm screws to attach the screen bezel to its base.

3) Connect the power cable to the MKS PI.

4) Put the MKS PI into the CPUBoardMainBody. Remove the uSD card before doing
so. Attach it to its top plate using four M2.5 x 10 mm screws.

5) Use two M5 x 10 mm screws along with two T-nuts to mount the module on the
printer. It was designed to be mounted on aluminum extrusion.

This object main web page is:  
http://www.ctheroux.com/makebase-mks-pi-and-ts-35-case/.

This object was designed using Solid Edge Community Edition.

You can request the source files on the page listed above.