Used to mount the hyperpixel 4" touchscreen display alongside the MK3S LCD outside the lack enclosure. I used a raspberry pi 4, no cable extensions needed for the prusa lcd screen.
Line the bottom of the mount base flush to the bottom of the lack table to insure clearance of the doors.
The print pictured above is in Red PETG by SPOOL3D, I used 0.10mm detail setting in prusa slicer but the gcode uploaded is for 0.20. Can used PLA if you wanted to this is just what I did.
Cheers!
Used to mount the hyperpixel 4" touchscreen display alongside the MK3S LCD outside the lack enclosure. I used a raspberry pi 4, no cable extensions needed for the prusa lcd screen.
Line the bottom of the mount base flush to the bottom of the lack table to insure clearance of the doors.
The print pictured above is in Red PETG by SPOOL3D, I used 0.10mm detail setting in prusa slicer but the gcode uploaded is for 0.20. Can used PLA if you wanted to this is just what I did.
Cheers!
Printer Brand: Prusa
Printer: I3 MK3S
Supports: No
Filament: SPOOL3D PETG Red
The author marked this model as their own original creation. Imported from Thingiverse.
