2023 Snowflake Photo Frame Christmas Ornament

Three models: The ornament, the photo cover and the template for marking your photo.

I printed this with PLA at 210c with a 60c heated bed on an Ender3 pro.

Use a fat, indelible marker (Like a Sharpie) to color the numbers and then spray with clear-coat to keep it from rubbing off. Alternatively you could paint the numbers or even change to black filament at layer 12.

Use the 35mm template to mark a circle on your photo. Carefully cut out the picture and place it on the round platform of the ornament. "Dry fit" the cover to see that it's looking good then remove the cover and add a drop of super glue to it's inside rim. Reseat the cover and hold in place until the glue is set.

Loop ribbon through the hole at the top of the ornament, sew it or snap the ribbon under the photo and cover to trap it.

Happy Holidays!