Yokomo YD2 Magnet Body Mount, perfect fitment!

Magnetic mounts for that perfect fitment! Works OK with most walltaps and smaller crashes :)
11
92
0
927
updated December 30, 2022

Description

PDF

Designed to be easily adjusted if needed for the perfect fitment, and works pretty well for walltaps due to the deep magnet cups! Additional hardware needed below, and pay attention to print orientations and mirroring the rear mounts. No supports needed!

4x magnets are needed, 10mm diameter, 2.5mm thick! I used these. Magnets are slid in from the side, no glue needed. the magnet holders are attached to the body using double sided tape and tape (aluminium tape in my case). When mounting the magnets to your body, put the double sided tape on the mounts and attach them to the M4 screws, then lower your body onto the magnets. Add supporting tape on the tabs.

 

For stock front bumper

  • 1x M4*16mm HEX screw with round head.
  • 2x M4*??mm HEX screw with round head, choose length for your body.
  • 2x M3*4mm screw, for mounting 
  • [OPTIONAL] 2x M2.5 stop screws, in combination with CA glue.

 

For small front bumper

  • 1x M4*16mm HEX screw with round head.
  • 2x M4*??mm HEX screw with round head, choose length for your body.
  • 2x M3*4mm screw, for mounting 
  • [OPTIONAL] 2x M2.5 stop screws, in combination with CA glue, not using M3 screws above.

 

For the rear mounts

  • 2x M4*??mm HEX screw with round head, choose length for your body.
  • If needed, insert the M4 screws at an angle in order for the magnets to attach properly.

/!\ The rear mounts needs one part to be mirrored on Z-axis, see orientation image!

 

Upper chassimount 

(Not recommended, very fragile and design abandoned.)

  • 2x M2.5*10mm hex screw (Sorry, not verified…)

Tags



Model origin

The author marked this model as their own original creation.

License