Prusa Mini Stepped Sheet Holder REMIX

This steel sheet holder is made from JamesThePrinter to hold three Prusa Mini sheets. Each sheet is held on its own step to make each sheet visible. This makes it easier to choose your desired sheet.

After James published the model this morning, I liked the design extremely well. Only I had doubts whether it would be sufficiently stable and not tip over too easily. That's why I'm not starting with a make of James' original, but with a remix.
I added a few square centimetres of support surface. In doing so, I took care to preserve James' fantastic design. 

Three sheets fit perfectly and hold stably in the notches.
If you like the model, please give the original a Like. A lot of creativity and time went into it.

I printed the holder with a 0.6mm nozzle.
Layer height 0.4mm, infill 15%.
 

I am looking forward to your Makes! :-)

If you like this model, feel free to check out my others here.

And maybe you would like to support me with a small donation. Feel free to use the support button on the top right of this page. I myself donate one or two Euros to each designer for an interesting model that is worth five stars to me.