Laser cut Filament Rack

This spool holder was designed in Fusion 360. It is made to hold 8x 20cm diameter spools. Plywood should be 6mm thick for optimal fit!

Assembly: There are 'flippers' which hold up the spools, you will need a 5mm pin of some sort to hold them in. I used 5mm rod stock cut to size. The flippers also come in 2 halves which will need to be glued together.

Print instructions

Unassociated tags: laser cut

Category: 3D Printer Accessories Summary

This spool holder was designed in Fusion 360. It is made to hold 8x 20cm diameter spools. Plywood should be 6mm thick for optimal fit!

Assembly: There are 'flippers' which hold up the spools, you will need a 5mm pin of some sort to hold them in. I used 5mm rod stock cut to size. The flippers also come in 2 halves which will need to be glued together.