REMIX! Great Design by MyTechFun
Tripod adapter for the Mintion Beagle Camera
UPGRADES:
Added more degrees of tilt
Minimized Hardware / Material
3 Versions:
See pics. Tolerances are tight enough that you use it without any hardware saving weight.
Tripod hole is just big enough that you can barely thread it on by hand and just tight enough that you should be solid for normal use. - Do Not Overtighten - Tolerances are very tight, but plastic can be always be stripped by the Hulk.
Uses STOCK HARDWARE!
No Supports needed
Printed with a .6 in PLA @ .28/.8
NOTE: When using the stock hardware it may “look” short when inserted. This will NOT affect anything. It will compress when you install the screw.
The author remixed this model.