Babylon 5 PPG Stand

Designed to fit my build of Metaform3d's PPG model but should work for the standard model too.

I added a M3 hex cap head at the front to hold the heatsink in place on my PPG build and the stand has a recess for a 6mm x 1mm magnet, glued in, that grips that screw but it works without that.

v5b has had the poly count for the dome and rod increased as requested. Its about as good as I could get without re-doing the entire model again.

Print instructions

Unassociated tags: Babylon 5

Category: Other Summary

Designed to fit my build of Metaform3d's PPG model but should work for the standard model too.

I added a M3 hex cap head at the front to hold the heatsink in place on my PPG build and the stand has a recess for a 6mm x 1mm magnet, glued in, that grips that screw but it works without that.

v5b has had the poly count for the dome and rod increased as requested. Its about as good as I could get without re-doing the entire model again.

Print Settings

Printer Brand: Creality

Printer: CR-10S

Rafts: No

Resolution: 0.2

Infill: 20% Gyroid but any will work

Filament: Technology Outlet PLA Galaxy Blue (more purple if you ask me but hey that's the colour)
Notes:

No supports required, takes just over 2 hours on my CR10S, sliced using Slic3erPE.