Multimeter Aneng AN8009 Stand Organizer

This Thing is to organize your multimeter. As you see the multimeter comes with a lot of accessories. When you need them you need to search for it, loose time, loose patience.

This Thing has all accessories in one box (even the little manual fits under the Aneng AN8009 itself). It is tailored to Aneng AN8009.

If you don't need the compartment with tilt function underneath,you can only print the upper part, and you're done.Both parts are meant to be glued together, I have incorporated an indexing hole in the upper part and locater pins in the bottom part. This may need a bit rework depending on what your printer did. The sizes are nominal, but you can easlily drill the holes a bit wider.

I give in that the stand mechanism is laid out a bit weakly, the rack size could be a bit more rigid. Feel free to adapt it yourself, to your needs. Mine is printed, mine is distributed in Thingiverse. I personally shouldn't have any more reason to change this again. You're welcome to do this.

Have fun, organize yourself and good luck with it.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

Your choice (medium to high)

Infill:

I choose 40%, maybe a bit too dense

Filament: doesn't matter Your choice (I took PLA) see photographs

Notes:

I printed mine with lower part and upper part as one piece. With support. The stowing compartments in the lower part were filles with 120g support material. It took me millions of years to take these out. And it printed (medium) over 19 hours.
My advise: use it two parts and glue them together, then, you only need support for the lower part, just a bit where the lift meachnism is. Upper part works fine without support. You'll have it are much quicker printed, may choose lower quality for lower part and high quality for upper part. And you save reworktime and filament!