Case for W1209 Temperature Control Switch

Needed a case for my temperature control switch (12V) W1209.

W1209 are available in 5, 12, 24V (maybe more). In my case I used one common 12VDC source and connected the relay contacts to switch my (noisy) cooling fan on and off.

Pretty simple.

Tip: I used four M3 "Brass Heat Set Inserts" but only used two screws in the rear. The front screws are too high for the lid. So you may save two brass inserts.

Print Settings

Printer:

Voron 0.1

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2mm

Infill:

15%

Filament:

Doesnt matter

Notes:

I printed the lid on the side, therefore, with raft and supports.