Reveal XB Snow and Rain Cover

To print, I just use a standard ASA profile from Prusa, 0.2 to 0.3mm is perfect. ASA or PETG is recommended since this will be outside in the elements.

For mounting you will need the following:

• 2x 4-40 x ½ stainless steel machine screws (counter sunk is best)
• 2x 4-40 stainless steel square nuts
  • This might be replaceable with 4-40 nylock nuts, and likely would work better but I couldn't get my hands on any at the local hardware store.

When attaching the roof, I recommend screwing the screw into the top of the roof and tightening it almost all the way. You will need to screw it into the roof, while there is a hole, the hole is purposefully smaller to avoid a lot of movement and to attach to the screw better.

Afterward, attach the square nut to the bottom of the screw and try to slide it into the top slots on your trail camera. Once you've slid both screws into the rail you can safely tighten the screws to whatever position you want.

I've only tried this with the Reveal XB cameras, but I believe this will also work with X and X Pro cameras. If you have a solar panel on your camera this will likely not work because it uses the same slots as the solar panel to attach.