phone holder for big phone and big cable

With others phones stands i struggled to make the charger cable pass or fit so i made my own. i tried to make it the more compatible possible The photo is a custom version. there isn't the drawing in the original model

Light Update

i made a thin version faster, lighter, smaller but less solid

What that phone holder has?

-Has hole for cable, phone button and sound

-It's easy to stamp a stencil on it to customize it.

-Chonky enough to be solid.

-I tested it stability, it is quite stable

-No Support needed

-Print in one piece

Seizes:

Overall seize: 103 x 102 x 189

scaled for: 73.6 mm large • 158.5 mm height • 7.9 mm deep phone (whiout phone case) Smaller phone can fit

effective seize of the phone hole: 78mm large, 17mm deep, 132,8mm high

cable :

-5cm high between the supportand the base to not damge the cable by bending it.

-can fit a cable end of 2cmm long 1,5 cm large

Print Settings

Printer Brand:

Anycubic

Printer:

All-metal Mega

Rafts:

Doesn't Matter

Supports:

No

Resolution:

1.5mm

Infill:

20% (can cause problem if under)

Filament: Polymaker PolyTerra pla Savannah Yellow

Notes:

the printer used is the anycubic Vyper but this was not a option
this model have tendency to warp. i recommend to use a brim if you have warping issues.

if the infill is too small the base will look like a baked pizza crust: a surface full of bubles

require bridge