Terrarium pool with filter chamber

Instructions(please read!):
The pool is a bit larger than the build plate of the MK3/S, so you have to either split the model into two parts in PrusaSlicer or scale it down before printing. When scaling please notice that you will also have to scale the lid.

What I did:
I cut it in two parts in the slicer, printed it and glued them together with epoxy glue.
(I even changed the length of the pool by just scaling the length of the splitted part that does not include the filter chamber).

I also sealed the inside of the pool with epoxy to make the pool waterproof (I assume it will slightly leak if you don't do this). 

Filter chamber:
The chamber is made in a way that you can add a filter sponge into the opening. I am using a small usb water pump to establish the movement of the water.

Chamber cover:
Just print it as is.