Dino Night Light w/Base

Remixed design to include a base to mount dinosaurs to and repost from Thingiverse.  I printed the original dinosaurs and made cuts/drilled holes on my build. The STLs here have the cut outs and screw holes on them.

Parts List
Govee 16ft RGB light strip - Self adhesive, bluetooth, lots of cool lighting effects in the app.
x6 M3x5mm screws - x2 per dinosaur to attach them to box lid
x1 M3x10mm screw - Used to secure power connector inside box.
RGB Extensions - I didn't use these but really wish I had, it would have made putting the lights and dinosaurs in a lot easier. Not to mention make replacing a dinosaur possible.

The light strip has 15 addressable sections. I've got four sections in each dinosaur and a single section inside the box between each dinosaur (with a spare at the end), filling them from left to right. If you are careful when doing this, fill effects will work out and look good.