Custom Front and Rear Wing for Traxxas 2WD Models (Rustler, Stampede, Bandit, Slash)

These wings are meant for Traxxas 2WD models only. (NOT the rustler 4x4 or slash 4x4)

Pls traxxas lawyers do not take this down again, this is a custom NON-TRAXXAS part..

Front wing installation:

The front wing comes in two parts: the Front Wing, and the Front Wing Mount. The Front wing mount mounts to the bulkhead where the stock bumper goes (it is meant to bolt on as a replacement with the same screws). The front wing then slides down on top of the mount with a friction fit. If the fit is too loose, add duct tape. If the fit is too tight, lmk and I can make a looser version. (I get an email when you comment)

Rear wing installation:

The rear wing comes in three parts: the Rear Wing, and the Left and Right Mounts. To install it, first bolt the left and right mounts to the rear gearbox where the stock wheelie bar is meant to go. (Don't worry - this part comes with mounting holes for the stock wheelie bar also.) Then, slide the rear wing on the tops of the mounts with a friction fit. The fit should be perfect if your printer has good tolerances.