Klean Kanteen Classic Cap Replacement (Clean Canteen)

This is a basic replacement cap for any Klean Kanteen Classic water bottle.  I wanted something basic and completely water-tight.  I'm happy to remix the model if you want other features like lanyard holes, or a carabiner hoop.

This model is printed in PETG and requires a Klean Kanteen Classic replacement gasket set which can be purchased on the Klean Kanteen website or Amazon.  I tried printing a TPU gasket but I could never get it 100% watertight, it was probably good enough for most people but I throw my water bottle in my backpack and didn't want it to spill at all.

The model can be printed upside down or right side up, the bridging is minimal and printed just fine on my Prusa Mini+.

Clean Canteen.
Created in Tinkercad by tbenz9.