Experimental Bridging Hot Air Balloon (1,100 bridges)

USE BRIMS - SLOW DOWN AS YOU GO HIGHER - MAY POP OFF PRINT BED

Based on earlier learning with Air Trees https://www.printables.com/model/340401-air-trees-easy I wanted to see what was possible at the upper end of the technique.

Recently I went for my first hot air balloon ride and it inspired me to create this shape.

This model has 1,100 bridges & an internal girder frame. It's designed specifically for .20mm layers.

Scaling: If you scale to 75% and change layers to .15mm it might work. Same with 50% scale and .10 layers although I'm not sure that will work.

I was at 90% and I tried to add some support and popped it loose myself.

===========================================

Too much? Try Air Trees! (Below)

https://www.printables.com/model/340401-air-trees-easy