Sprite Pro CR-Touch mount remix

This is a remix of a Cr Touch mount for a Sprite Pro. Please follow link below for detailed instructions on how to install. https://www.printables.com/model/255096-sprite-extruder-ender-s1-pluspro-cr-touch-mount-fo/remixes

I remixed v3 of Cr Touch mount for a Sprite Pro DD, to probe closer to the right side of build plate. My Offsets: X-38.3mm, Y-9.4mm (original X-55.5mm, Y-0mm  make sure to check your own offsets, use mine to get you close. Then save your offsets to firmware. You will need to tap the cr touch screw holes with a 3mm tap.

My Print Settings

Layer height: 0.12mm
Base layer height: 0.12mm
Infill: 75%
Material: PLA+
Walls: 3
Printer: Ender 3 v2
Supports: Build plate