Simpson GUS construction based 3D printer

Variant of fully printed 3D printer based on Simpson GUS concept.

Printer was modified to be able to use squared heated bed and touch probe. As firmware was intended to be used modified Marlin with standard Atmega2550 and Ramps 1.4 board (design to cost ;-)).

Construction was built and used for a while, but project was discontinued due to switch on cartesian CoreXY variant of printer later. However I was so impressed by this construction so I decided to put it here for someone who want to try to make it running ;-)

Here are some videos from quick tests of printer mechanics and modified Marlin FW:

Print instructions

Category: 3D Printers Summary

Variant of fully printed 3D printer based on Simpson GUS concept.

Printer was modified to be able to use squared heated bed and touch probe. As firmware was intended to be used modified Marlin with standard Atmega2550 and Ramps 1.4 board (design to cost ;-)).

Construction was built and used for a while, but project was discontinued due to switch on cartesian CoreXY variant of printer later. However I was so impressed by this construction so I decided to put it here for someone who want to try to make it running ;-)

Here are some videos from quick tests of printer mechanics and modified Marlin FW:

• https://youtu.be/ESs8r99B3E4

  Print Settings

Printer: Rebel II

Rafts: No

Supports: No

Resolution: 0.4

Infill: 20%

Filament: Plasty Mladec PLA any