Ender 3 Pro Direct Drive Filament Guide

If you Upgraded your Ender 3 Pro to Direct Drive you may want to attach a Filament Guide to your printer. Here's a simple solution.

Note: The Hole where the FIlament goes through fits a Ø4mm PTFE Tube. Just put the Tube inside and cut it to your desired length.

There are two versions:

*Tight fit: Fits very tightly to the Aluminium Extrusion, may need a bit of afterwork to properly work, but I recommend this Version.

*Loose fit: Fits loosely to the Aluminium Extrusion, no afterwork is needed if printed properly.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

Rafts:

No

Supports:

Yes

Resolution:

0,18-0,24mm

Infill:

25-30%

Filament: OWL PLA Orange