TaoTronics / Paris Rhône Cool Mist Humidifier Replacement Filter

Replacement filter for the TaoTronics / Paris Rhône Cool Mist humidifier. It's not perfectly watertight, but it works fine with careful tank placement and removal. 

The largest part (the container) can be printed with PLA, 0.15mm, with supports.

The bottom cap and the screw can be printed with PLA, 0.15mm, without supports. 

The seal ring and cone should ideally be printed with a flexible filament, such as 92A. Make sure to use low print speeds (max 20 mm/s) and zero to no retraction. If you do not have flexible filament, you can skip the seal ring, but you will still need to print the cone to help prevent water spillage.

You can place a demineralization cartridge (such as https://www.amazon.com/dp/B09YTZ43JR ) inside the filter.

You need to separately order a 0.4x5x20mm (0.016"x0.2"x0.79") spring.