Guitar Knob - 6mm Split Shaft Pot (Press Fit) Remix v1

This is a remix of the original File by Back37strad. My main goal for this was to make an actual knob smaller compared to the original in height. You can see in the images how it compares to the standard knobs on my beautiful Ibanez AZES31. I went on Tinkercad and cut the knob down at the end of the inner shaft and put the top back on it to achieve this. this worked amazingly well with PETG but I'm more then sure it could be down in PLA. I printed out two of these at once and worked amazingly. 

Print Settings

Rafts:

No

Supports: 

No

Resolution:

.15 (.15 Quality if using prusa slicer)

Infill: 

15%

Utilizing TinkerCad, I adjusted the height (seen in the pictures) to look closer to a traditional guitar knob