Anbernic RG353V Snap On Face Protector

Prints fine without supports. Turn on ironing to clean up the inside faceplate that actually makes contact with the rg353v. I used a roll of felt tape to line the inside from amazon. This is really rough as this is my first remix but works well for my needs. Will be doing some micro adjustments to sizing but seems to keep the handheld from not falling out.

12/23/2022 update: realized there was a small line gap on the faceplate which if the printer is too dialed in will be pronounced in the print. fixed it and adjusted the height to make the plate alittle tighter

12/25/2022 update: make the directional pad bigger so the handheld sits flush against the cover

01/16/2023 update: moved the "wings lower makes for a better fit and snugness to the handheld