ASUS ZenWiFi Pro ET12 Wall Mount Bracket

This allows you to put the ASUS ZenWiFi Pro ET12 on the wall. It is designed for the ET12 to drop into the wall mount and the ET12 will not move around. There is enough space in the back for cables.

Print Instructions:

1. Print strong in PETG/PA/PC/CF is recommended.
2. Print with minimum of 4 top layers and 4 walls. Personally I did 5 walls, 5 top layers and 25% gyroid infill with PETG @ 280c. It is nice and strong that way.
3. Printing on draft settings (0.28mm+ layer height) for faster print is OK.
4. No supports are needed.
5. Print one for each ET12 you have.

Install Instructions:

1. Screw into the wall, there are 3 screw holes.
2. Use long screws appropriate for the type of wall you are mounting to.
3. Use drywall anchors if securing to drywall and not into a stud.
4. Set ET12 unit on and into the mount.