N+1 Modular Wire Spool Dispensers

--V1.2--

Added _TS for those who wants to print without corner brims and smaller spindle to accommodate wire spools with smaller internal diameter.

--V1.1--

Adjusted fittings of conical ends to the spindle.

--V1--

Too many wire spools, needed a way to organise and label them. Plus I wanted to try out some fitting techniques.

All the parts snap/slide fit together.

--Open to suggestions!--

Print instructions

Optimised
0.3mm layer height, 4 top and bottom layers
2/3 Shell, 5% infill
Support from built plate only, enable bridging.
Brim not recommended
~85g of PLA used

or whatever settings you are comfortable with