White Rabbit with Quartz Clockwork

When I first saw this stunning model from Reddadsteve, I directly knew this would be the perfect Clock for my apartment.

I printed all the parts of the rabbit at 150% and had no problems, with 2 exceptions:

I printed the Body_Pin at 160% except for the lenght,

and I printed the Glasses_Lenses at 145% (Clear PETG)

I redesigned the whole watch, it now can fit a Quartz clockwork (55.8x55.8x15.4mm), I took the clockwork out of a 3€ clock.

I reused some of the parts of the original watch (at 150%), those were:

-watch_rim1

-watch_rim2

-watch_face (I drilled out the hole to 6.5mm)

-numbers

One problem was that you could see the clockwork trough the thin watch_face (I used glow in the dark PLA), so i put a sheet of paper behind it.