Dog Poop Bag Wall Dispenser

Simple customizable wall mounted dispenser for dog poop bags.

Print parts and cut to size two equal sizes of an aluminum angle with 1/16 inches thickness and 3/4 inches width for the rails. For my build I used one of these that I cut in half: https://www.homedepot.com/p/Everbilt-3-4-in-x-36-in-Aluminum-Angle-Bar-with-1-16-in-Thick-801377/204273984

Tails will slide into place and hold their positions after you secure the top and bottom part each with a screw into the wall, final part that holds the bag needs to be glued to bottom part.

Print instructions

You need to print the Top / Bottom part twice. Make sure to observe the orientation in your print bed so that the flat side is facing down

No support materials needed!