Victorinox Toothpick Replacement 50mm - actually good quality model

As I could not find any really good models of the standard Victorinox Toothpick, I designed my own in a few iterations. This is now the fourth version.

It fits all my (by now relatively large selection of) Victorinox Swiss Army Knives with the standard 50mm toothpick.

The green one in the pictures is the original, the white ones are printed (PLA). The fit is almost as good as the original, even though I had to clean up the print a bit. I recommend using a small nozzle for the rather small part, it did work with an 0,4 but the 0,2 nozzle gave much better results. 

I also recommend to print it with at least 3 perimeters (not infill left) and with very low layer height. It doesn't take long anyways.

I already printed a bunch of colours - can you spot which are printed and which are original?