Heat set insert press clamp for Hakko FX888D/FX8801

Clamp for the Hakko FX-8801 handpiece (supplied with FX-888D) from fns720's heat-set insert press modified to fit thrutheframe's press for 2020 extrusion and MGN9 rail.

The clamps are secured with a 40mm M3 bolt. Two versions are supplied, one for a regular 40mm bolt and another with the a top surface recessed to fit Elothan's printed thumb screw.

It's really not required but the bottom of the clamp supports insertion of an M3x4.6x3 heat press insert should you wish to use one.

The hinge is printed in place and should open with a moderate amount of pressure after printing.

The model is designed to print with a 0.4mm nozzle at 0.2mm layer height. It's possible the clamp may get hot with extended use, so consider printing in a more heat resistant material than PLA.