120mm fan cover

120mm fan cover with magnet. 

I used this to cover an custom designed exhaust fan enclosure on top of my FlashForge Creator Pro 2 when printing ABS to keep the heat in the chamber.  

I bought the AC Infinity dual fans because it had speed control whereas the single does not.  It should fit any similar 120mm fan.  It fits snugly and had a cut out for the cord.  The magnet is a backup to hold it in place and uses a single 3x1mm magnet that is heat set into the cover. The cover does have a centered hole to insert the magnet into.

I used a soldering iron to push the magnet into place.

Fan Link:  https://amzn.to/3V3dt9L

3x1mm Magnets:  https://amzn.to/3PAM268