H4 / HS1 male plug adapter for flat cable lug

I made a plug for an adapter to connect the new LED-headlight to my 2016 Vespa Sprint 125 ABS iget.

Needed:
AMP Superseal plug 3 pin
some wires. 1,5mm²
Cable lug as shown in picture. I had only some 2,5mm² left. So I folded the end of the wires and crimped them.

Be care full, when you are connecting the plug. The lug could move back.

Everthing works fine. I isolated the original plug with kapton tape and some textile tape to keep it from ground.

Print instructions

Category: Automotive Summary

I made a plug for an adapter to connect the new LED-headlight to my 2016 Vespa Sprint 125 ABS iget.

Needed:
AMP Superseal plug 3 pin
some wires. 1,5mm²
Cable lug as shown in picture. I had only some 2,5mm² left. So I folded the end of the wires and crimped them.

Be care full, when you are connecting the plug. The lug could move back.

Everthing works fine. I isolated the original plug with kapton tape and some textile tape to keep it from ground.

Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: Doesn't Matter

Supports: No

Resolution: 0.2

Infill: 15%

Filament: nunus petg yellow
Notes:

make it strong.