QIDI X-Max for MKS-Pi Klipper Screen TS35 Adapter

This Adapter is for all QIDI users who want to upgrade to the MKS-Pi system for using Klipper in the future.

You can order this system on amazon here: Makerbase MKS-Pi with preinstalled Klipper

To add the screen to your X-Max, you also need a longer, at least 1m long ribbon cable which can be found here: 300mm extension cable 24p 0,5pitch with an extension adapter

Preparing:

Use 4 heat inserts with max. 5mm hight and place them on the back of the display adapter.

heat inserts can be found here: Heat inserts M3x5x4

Assambling:

Disassamble the side parts of the X-Max as well as the front.

The Display is mounted with 4 screws. Take it off and place the TS35 adapter instead.

Place the display inside and mount it with 4 screws to the adapter as well.

The ribbon cable follows the way of the old ribbon cable.

Installing the MKS-Pi Klipper:

Follow the instructions on github:

Github page of Makerbase

by logging in with command prompt, use “ssh mks@[your ip adress]” password: makerbase

For installing a proper version of Klipper Follow the instructions of NexGen:

Github page of Nexgen

How you get the Klipper system running on your QIDI printer is explained here:

QIDI Flashing vor Klipper

Printing instructions:

Print was done with Prusament ASA Galaxy Black But you can also use Extrudr ASA Black

• Supports: no 
• Perimeters: 2
• Infill: 30%
• Top/Bottom: 1 mm

Smooth it if you like with acetone.

link to my smoother is here: Acetone Vapor Polisher for ABS and ASA prints

Als Amazon-Partner verdiene ich an qualifizierten Verkäufen