Nano Pi Neo Case (with and without antenna hole)

This is a case for the NanoPi Neo without heatsink.

As I needed an antenna hole in the top, I've completely redone the case in Fusion 360 - see Remix section for source: https://www.thingiverse.com/thing:4398131

I've redone the venting and made some walls thicker as they did break quite easily in the original. I also got rid of the need for nuts and the case is now simply heald together by four M2,5 x 25mm screws which screw directly into the according holes.

There's also a version without the antenna hole.

Keen on your feedback :-)
Cheers,
Patrik

Print instructions

Category: Electronics Summary

This is a case for the NanoPi Neo without heatsink.

As I needed an antenna hole in the top, I've completely redone the case in Fusion 360 - see Remix section for source.

I've redone the venting and made some walls thicker as they did break quite easily in the original. I also got rid of the need for nuts and the case is now simply heald together by four M2,5 x 25mm screws which screw directly into the according holes.

There's also a version without the antenna hole.

Keen on your feedback :-)
Cheers,
Patrik

Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 20%

Notes:

Print with support if needed, had no problem with the gaps without it.