Stand for Magic Keyboard / Magic Trackpad (1 location)

Why I created support?
10
113
1
722
updated June 11, 2020

Description

PDF

Why I created support?

I wanted to be able to put my Magic Keyboard vertically on a support but I could not find any model, this in order to make room on my desk to be able to use the most space to be able to work.

So I created my own support and I hope you like my work

Publish

I would be delighted if you took pictures of the impression of my work.

PRINT CONFIGURATION

I did a print test with a filling of 70% and it was good, but I advise you for an optimal result to make a filling of 90% or even 100%

For the layer height I advise you to make0.15mm but 0.20mm should be good too, it will depend on your desire to have a logo and smooth border or not

YOU ARE LOOKING FOR A MODEL WITH TWO LOCATIONS ?

You can find other version with two locations here

Changes

07/06/2020

  • Add logo on second walls
    09/06/2020

  • Center Logo

  • Add version : Round edge 5mm
  • Add version : Round edge 10mm
  • Add version : Round edge 5mm with no wall edge rounds
  • Add version : Round edge 10mm with no wall edge rounds
  • Add version : Without any edge

Print instructions

Unassociated tags: Magic Keyboard

Category: Computer Summary

Why I created support?

I wanted to be able to put my Magic Keyboard vertically on a support but I could not find any model, this in order to make room on my desk to be able to use the most space to be able to work.

So I created my own support and I hope you like my work

Publish

I would be delighted if you took pictures of the impression of my work.

PRINT CONFIGURATION

I did a print test with a filling of 70% and it was good, but I advise you for an optimal result to make a filling of 90% or even 100%

For the layer height I advise you to make0.15mm but 0.20mm should be good too, it will depend on your desire to have a logo and smooth border or not

YOU ARE LOOKING FOR A MODEL WITH TWO LOCATIONS ?

You can find other version with two locations here

Changes

07/06/2020

  • Add logo on second walls
    09/06/2020

  • Center Logo

  • Add version : Round edge 5mm
  • Add version : Round edge 10mm
  • Add version : Round edge 5mm with no wall edge rounds
  • Add version : Round edge 10mm with no wall edge rounds
  • Add version : Without any edge

    Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: No

Supports: No

Resolution: 0.15

Infill: 70% or more

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License