Simple Angel Treetopper in Vase Mode - fast print with wings with infill pattern

Simple Angel Treetopper in Vase Mode - fast print with wings with infill pattern

If you like it --> press like it :-)

Very fast to print, nice finish and easy to assemble and illuminate. Can be used for decoration on e.g. a shelf, as treetopper or as light.

The body is designed for 0.8mm line width and vase mode. 

It is without problems possible to print with a 0.4mm nozzle a line width of 0.6 to 0.8mm. Slightly increase the temperature.

You may have openings at the top. You can get better results if you increase the flow at the higher layers.

You can simply change the height of the angel when you move it in the slicer downwards. With that you can create a group of angels with different height. The print in the pictures is moved 50mm below the printer bed.

I recommend to print the wings in normal mode with zero bottom and top layer and vary the design with the infill pattern. The picture shows 20% gyroid.

If you like vase mode prints especially which are no vases, you can join our group https://www.printables.com/de/group/vase-mode-explorations-everything-but-vases-15zYdDQ/comments

Would be happy to see your makes!