Gamepad case for Radio Shack's Make: it Robotics Infrared Controller

This is a gamepad case for my Radio Shack Make: it Robotics infrared remote controller (Amazon) (Radio Shack #2770168)

The buttons are labeled to be used for an Arduino rover with an ultrasonic sensor and three servos. So it moves the robot and the sensor...

The zip file contains all the assembly parts, including the remote controller (for reference).

You will need two small screws, about 1//8 diameter x 1 in. I just used two screws I found...

Print instructions

Category: Electronics Summary

This is a gamepad case for my Radio Shack Make: it Robotics infrared remote controller (Amazon) (Radio Shack #2770168)

The buttons are labeled to be used for an Arduino rover with an ultrasonic sensor and three servos. So it moves the robot and the sensor...

The zip file contains all the assembly parts, including the remote controller (for reference).

You will need two small screws, about 1//8 diameter x 1 in. I just used two screws I found...

Print Settings

Printer Brand: Prusa

Printer: Prusa Steel

Rafts: No

Supports: Yes

Resolution: 0.15

Infill: 15%

Notes:

Rotate the cover_top part so that it lies with the inside up.